Komatsu — EVERY 500 HOURS SERVICE

. MAINTENANCE SERVICE PROCEDURE MAINTENANCE SERVICE PROCEDURE cap: 11 Nm (1.0 kgm ) When the O-ring has been replaced, coat the surface with clean fuel before installing it. coat the packing surface thinly with oil, then 4 - 64 3. Open up the engine side c over on the left side of the machine. 4. Put a container under filter cartridge (4) to receive draine d oil. 5. Remove connector (2) of After removing the conne the water separator caution l amp. prevent water from getting 6. Turn transparent cap (3) t (This cap is to be used again, so replace it with a new one if th ere is any damage on it.) 7. Using a filter wrench, turn cartridge (4) to the left to remo ve it. 8.

Fix earlier removed cap (3) to the base of a new filter cartridge. At that time, be sure to rep lace the O-ring (6) with a new one. Specified tightening tor 9. When installing, bring the p acking surface into contact wit h the seal surface of filter cartrid -1/2 turns. If the transparent cap is tig htened too much, the O-ring m ay be damaged, and this will c ause leakage of fuel. If it i s not tightened enough, fuel will leak through the gap at the O -ring. Always be sure to tighten t 10. Clean the filter holder, fill t install to the filter holder. NOTICE When adding fuel, do not remo ve cap (B). Always add fuel from the 8 small holes (A) on the dirty side . B) and install the fuel filter.

After adding fuel, remove cap ( Always fill with clean fuel. Be c areful not to let any dirt or dust ge t into the fuel. In particular, center po rtion is the clean side, so do not re move cap (B) when adding fuel. Be ca reful not to let dirt or dust get into c enter portion on the clean side.