. MAINTENANCE SERVICE PROCEDURE REMARK may light up. 4 - 65 11. When installing, tighten until the p acking surface contacts the seal surface of the filter holder, then tighten it 3/4 of a turn. f the filter cartridge is tightened to o far, the packing will be damaged and this will lead to leakage of f uel. I f the ilter cartridge is too loose, fuel wil l also leak from the packing, so always tighten the correct amount When tightening with a filter wr ench, be extremely careful not to dent or damage th e filter 12. Make sure that drain plug, which i s provided in the lower part of transparent plug (3), is firml Specified tightening torque of drai .3 lbft) 13.
Remove the vinyl bag covering co If When removing connector (2), be extremely careful not to let water get on the connec If water gets on connector (2), dry 14. Turner valve (1) at the bottom of t 15. After completing the replacement Blee d the air as follows: o FULL mark on the fuel gauge). h and turn the key to the ON ated. 16. Add fuel to the fuel tank until full (t 17. I nsert the key in the starting switc position (B). The electric priming pump is actu position (B). The electric priming pump is actu 18. Hold the key at the ON position (B i t to OFF position (A) and wait for 19. Repeat Steps 17 and 18 four time 20.
Start the engine, check that there is no leakage of fuel from the filter seal surface or w ater separator mounting urface, then run for approx. 10 m