. MAINTENANCE SERVICE PROCEDURE CHANGE OIL IN HYDRAULIC TANK, REPLACE OIL FILTER ELEMENT WARNING The parts and oil are at high temperature immediately after the engine is stopped, and may cause burns. Wait for the pressure WITH (2) valve LEVEL IN HYDRAULIC TANK, ADD OIL (PAGE 4-54)". 4 - 75 VERY 2000 HOURS Maintenance for every 50, 250, 500 and 1000 hours servic e should be carried out at the sa temperature to go down be When removing the oil fille r cap, turn it slowly to release the in Refill capacity: 55 liters (14.53 US gal) 1. Lower the work equipm ent to the ground, then stop the 2. Turn the cap of oil fill er (F) to release the internal pr p. dition type.
d of cap with the lock, see "CAP before removing the ca The cap is the lock ad About handling metho LOCK (PAGE 3-49)". 3. 4. Remove the cover (1) Loosen drain valve (2 again, then install cove at the bottom of the hydraulic ta ), drain the oil, tighten drain va r (1). When loosening drain valve 5. 6. 7. careful not to get oil on Remove bolt (3), then Take out spring (5), va Clean the inside of the (6). yourself. remove cover (4). lve (6), and element (7). case, then wash spring (5) an , valve (6), and spring (5). lt (3). 8. Install new element (7) 9. Install cover (4) with bo 0.
Add the refill amount o f engine oil through oil filler port (F), then EMARK f the cap is not installed c orrectly, it will cause leakage of When installing the cap, tu rn it to be locked securely until a click is 1. Check that the oil is at the specified level. For details,