N40469 Chapter 3 How to start the engine 1. Switch on the electrical system (1). 2. Adjust the engine speed control to the minimum speed position. 3. Press and hold the start switch (2) to engage the starter motor, there may be a short delay if the cold start aid is required (this is an automatic process when the temperature is below 5 O C. If the digital control panel is used, a message will flash up with ‘Wait to Start’). When the engine starts, adjust the engine speed control to give an even idle speed. Check that water comes out of the end of the exhaust pipe or out of the separate discharge outlet.
Always ensure that the engine and starter motor are stationary before the starter motor is engaged again. Figure 6 Page 15