N40469 Chapter 5 How to check the drive belt of the alternator Warning! The engines have a guard fitted to give protection from the alternator fan and the drive belt. Ensure that this guard is fitted before the engine is started. Note: The engine may have the ability to auto start. Ensure that the power supply is isolated before any service or repair is performed. To maximize the engine performance, inspect the belt for wear and for cracking. Replace a belt that is worn or damaged. If the belt is too loose, vibration causes unnecessary wear on the belt and the pulley. 1. Undo the bolts (figure 9 item 1) and remove the guard (figure 9 item 2).
After inspection of the belt or adjustment of the belt, refit the guard. 2. To accurately check the belt tension, use a belt tension gauge. Install the gauge (figure 10 item 1) at the centre of the longest free length and check the tension. 3. The correct tension for a used belt is 355N (79.8 figure 9 lb). If the tension of the belt is below 250N (56 lb) adjust the belt to 355N (79.8 lb). 4. The correct tension for a new belt or new belts is 535N (120 lb). A higher tension is required in order to compensate for the stretch that is in a new belt. Only use the higher tension on a belt that has not been used.
A used belt is a belt that has been in operation for 30 minutes or a longer period of time. 5. Alternatively if a tension gauge is not available a useable option is to use moderate thumb pressure at the centre of the longest free length and the correct tension will be 10mm. 6. Align the guard to the engine. Install the bolts and tighten securely. Figure 10 Page 31