puls — Puls 1106 Series Marine Propulsion Engines User's Handbook

N40469 Chapter 5 How to renew the element on the primary fuel filter Warning! Fuel leaked or spilled onto hot surfaces or electrical components can cause a fire. To help prevent possible injury, turn the start switch off when changing fuel filters or water separator elements. Clean up fuel spills immediately. Note: Refer to, “Cleanliness of Fuel System Components” in the Installation Manual for detailed information on the standards of cleanliness that must be observed during ALL work on the fuel system. It is important to maintain extreme cleanliness when working on the fuel system, since even tiny particles can cause engine or fuel system problems.

It is important to maintain extreme cleanliness when working on the fuel system, since even tiny particles can cause engine or fuel system problems. Note: Ensure that the engine is stopped before any servicing or repair is performed. After the engine has stopped, you must wait for 60 seconds in order to allow the fuel pressure to be purged from the high pressure fuel lines before any service or repair is performed on the engine fuel lines. If necessary, perform minor adjustments. Repair any leaks from the low pressure fuel system and from the cooling, lubrication or air systems. Replace any high pressure fuel line that has leaked. Caution:

Do not open high pressure fuel lines to bleed the fuel system as it is self bleeding Ensure that all adjustments, maintenance and repairs are performed by authorized personnel that have the correct training. Typical example 1. The engine can have the ability to auto start. Ensure that the power supply is isolated before any service or repair is performed. 2. Turn the fuel supply valve to the OFF position before performing this maintenance. 3. Place a suitable container under the water separator in order to catch any fuel that might spill. Clean up any spilled fuel. Clean the outside of the water separator. Figure 16 4.

Disconnect the wiring harness (5) from the sensor on the bottom of the bowl (4). 5. Open the drain valve (6). Allow the fluid to drain into the container. Tighten the drain valve by hand pressure only. Page 35