puls — Puls 1106 Series Marine Propulsion Engines User's Handbook

Chapter 5 N40469 6. Rotate the bowl counter clockwise in order to remove the bowl. Remove ‘O’ ring seal (3). Clean the bowl. 7. Use a chain wrench in order to remove old canister (2). 8. Lubricate the ‘O’ ring seal (1) with clean engine oil on the new canister. Install a new canister. Caution: Do not prefill. 9. Spin on the canister until the ‘O’ ring seal contacts the sealing surface. Then rotate the canister 3/4 of a full turn. Do not use a tool in order to install the canister. 9. Install a new ‘O’ ring seal into the bowl. Lubricate ‘O’ ring seal (3) with clean engine oil. Install the bowl onto the new canister. Tighten the bowl securely. Install the wiring harness to the sensor. 9.

Open the fuel supply valve. Remove the container and dispose of the fluid in a safe place.. Page 36