N40469 Chapter 5 How to renew the element on the secondary fuel filter Warning! Fuel leaked or spilled onto hot surfaces or electrical components can cause a fire. To help prevent possible injury, turn the start switch off when changing fuel filters or water separator elements. Clean up fuel spills immediately. Note: Refer to, “Cleanliness of Fuel System Components” in the Installation Manual for detailed information on the standards of cleanliness that must be observed during ALL work on the fuel system. It is important to maintain extreme cleanliness when working on the fuel system, since even tiny particles can cause engine or fuel system problems.
It is important to maintain extreme cleanliness when working on the fuel system, since even tiny particles can cause engine or fuel system problems. Note: Ensure that the engine is stopped before any servicing or repair is performed. After the engine has stopped, you must wait for 60 seconds in order to allow the fuel pressure to be purged from the high pressure fuel lines before any service or repair is performed on the engine fuel lines. If necessary, perform minor adjustments. Repair any leaks from the low pressure fuel system and from the cooling, lubrication or air systems. Replace any high pressure fuel line that has leaked.
Ensure that all adjustments, maintenance and repairs are performed by authorized personnel that have the correct training. Typical example 1. The engine can have the ability to auto start. Ensure that the power supply is isolated before any service or repair is performed. Figure 17 2. Turn the fuel supply valve to the OFF position before performing this maintenance. 3. Use a chain wrench in order to remove old canister (2). 4. Lubricate the ‘O’ ring seal (1) with clean engine oil on the new canister. Install the new canister. Caution: Do not use filter where the wrapping is damaged. Do not prefill. 5. Spin on the canister until the ‘O’ ring seal contacts the sealing surface.
Then rotate the canister 3/4 of a full turn. Do not use a tool in order to install the canister. 5. Open the fuel supply valve. Remove the container and dispose of the fluid in a safe place. Page 37