puls — Puls 1106 Series Marine Propulsion Engines User's Handbook

Chapter 5 N40469 How to renew the lubricating oil of the engine Warning! Discard the used lubricating oil in a safe place and in accordance with local regulations. 1. Attach a suitable length of hose on the sump pump (figure 18 item 1) and place a suitable container with a capacity of at least 16 litres (28 UK pints) at the other end. If possible, the lubricating oil should be drained while it is still hot. 2. Pump until all the oil is drained. Caution: Do not fill the sump past the notch (mark) on the dipstick as this can have an adverse affect on the performance of the engine or damage the engine. Excess lubricating oil must be drained from the sump. 2.

Clean the area around the filler cap on top of the rocker cover. Remove the cap (figure 19 item 1) and slowly add approximately 15 litres of new and clean lubricating oil of an approved specification to the engine. Allow the oil enough time to pass to the sump. Remove the dipstick (figure 20 item 1) and ensure that the lubricating oil is to the full mark. Do not exceed the full mark on the dipstick. Fit the filler cap and ensure that the dipstick is fitted correctly in the dipstick tube. Figure 18 Note: Renew the filter canister when the lubricating oil is renewed. Figure 19 Figure 20 Page 38