N40469 Chapter 5 How to renew the canister of the lubricating oil filter Warning! Discard the used canister and lubricating oil in a safe place and in accordance with local regulations. 1. Put a tray or plastic bag under or around the filter to retain spilt lubricating oil. 2. Remove the filter canister (figure 21 item 1) with a strap wrench or similar tool. Ensure that the adaptor (figure 22 item 1) is secure in the filter head. Then discard the canister. 3. Clean the filter head. 4. Lubricate the top of the new canister seal (figure 22 item 2) with clean engine lubricating oil. Caution: Do not prefill with oil. 1.
Fit the new canister until the surfaces make contact, then tighten it by hand an extra 3/4’s of a turn only. Do not use a strap wrench. Figure 21 2. Ensure that there is lubricating oil in the sump. Operate the starter motor until the oil pressure warning light is extinguished or there is a reading on the gauge. 3. Operate the engine and check for leakage from the filter. When the engine has cooled, check the oil level on the dipstick and put more oil into the sump, if necessary. Caution: The canister contains a valve and special tube to ensure that lubricating oil does not drain from the filter. Therefore, ensure that the correct canister is used. Figure 22 Page 39