N40469 Chapter 5 How to check the valve tip clearances Check the valve lash while the engine is stopped. The temperature of the engine does not change the valve lash setting. Warning! Accidental engine starting can cause injury or death to personnel. To prevent accidental engine starting, turn the ignition switch to the OFF position and place a ‘DO NOT OPERATE’ tag at the ignition switch location. Note: Number one cylinder is at the front of the engine or where the vibration damper is. Cylinder number six is at the flywheel end. TC Compression Stroke 1. Remove the valve mechanism cover. Figure 28 2. Rotate the crankshaft in the direction of engine rotation until the inlet valve of the No.
6 cylinder has opened and the exhaust valve of the No. 6 cylinder has not completely closed. The engine is now at TC compression stroke. 3. Measure the valve lash for the valve when the engine is at TC compression stroke according to the table below. If necessary, make an adjustment to the valves accordingly. 4. Loosen the valve adjustment screw locknut (3) that is on the adjustment screw (2). 4. Place an angled feeler gauge (1) between the rocker arm and the valve. Turn the adjustment screw (2) while the valve adjustment screw locknut (3) is being held from turning. Adjust the valve lash until the correct specification is achieved. 4.
After each adjustment, tighten the valve adjustment screw locknut (3) while you hold the valve adjustment screw (2) from turning. 4. Rotate the crankshaft in the direction of engine rotation to TC exhaust stroke (360° from TC compression stroke). Page 43 TC Compression Stroke Inlet Valves Exhaust Valves Valve Lash 0.35 mm (0.0138 inch) 0.35 mm (0.0138 inch) Cylinders 1-2-4 1-3-5