DRIVING - Engine Operations pressed since the vehicle has been started. In vehicles with Eaton transmissions, the cruise control switches may be located on the shift control knob. Press the + button on the Right Steering wheel pod if available. Press the SET portion of the SET/RESUME button on the dash 2. To decrease speed: How to Use Set Cruise Control Speed When Driving 2. Accelerate the vehicle via accelerator pedal to the desired cruise speed. 3. Press the "SET" button to set the cruise speed. Information on using the cruise control. Press the - button on the Right Steering wheel pod if available.
Press the RESUME portion of the SET/RESUME button on the dash 4 This vehicle may have cruise control switches located on the steering wheel instead of the switches on the dash board. The instructions are still the same. these instructions do not apply to Adaptive Cruise Control. While the buttons are also used to control PTO operations, these instructions are specifically for vehicle speed. The vehicle speed must be greater than 19 mph (30 kph) for PACCAR powered vehicles or 30 mph (49 kph) for Cummins powered vehicles and the engine speed must be over 1,100 rpm for the cruise set speed to work.
NOTE Cancelling and Resuming Cruise Control Cruise Control may not hold the set speed going down hills. If the speed increases going down a hill, use the brakes to slow down. This will can- cel Cruise Control. At times the operator will need to override cruise control and take over. There are three ways to cancel the set speed in cruise control: The cruise set speed will appear in the instrument panel display. 1. Tap the brake pedal 2. Tap the clutch pedal 3. Turn the cruise control system off (ON/OFF button on steering wheel or the CANCEL button on the dash) How to Change Cruise Set Speed To Set the Cruise Speed 1.
Turn the cruise function on by using the ON/OFF button Once the cruise set speed is set, the operator can push certain buttons to increase or decrease speed. The cruise icon will appear in the instrument panel display. The vehicle cruise control must be on and the cruise speed engaged. Using the brake or clutch pedal to cancel set speed allows the operator to use the RESUME feature. Pressing the RESUME button will resume the vehicle speed previously set. 1. To increase speed: 102 Y53-6096-1A1 (01/17)