PACCAR 520 — Operating Manual Transmissions

DRIVING - Transmission When turning the system off, the previous set speed is removed from memory. The operator will have to manually reset the cruise speed. will allow your clutch to slip, causing excessive heat and wear, damage could result. brake. A non functioning clutch brake will make shifting very difficult when the vehicle is stationary. 1. Depress the clutch pedal past the first 1/2 inch (13 mm) for approximately 5 1/2 in (139.7 mm) of total pedal travel. 2. Depress the clutch pedal another 1/2 in (13 mm) to engage the clutch brake. When you must idle your engine for any period of time, shift your transmission to neutral and disengage the clutch (take your foot OFF of the pedal).

This helps prevent unnecessary wear to your clutch release bearing, and it is less tiring for you, too. Transmission How to Use the Hyrdaulic Clutch Certain vehicles have a hydraulic clutch to shift a manual transmission. Always use the clutch when making upshifts or downshifts. Never coast with the transmission in neutral and the clutch disengaged. To provide smooth gear engagements while shifting, use proper coordination between shift lever and clutch. 4 The clutch brake is used for stopping transmission gears, allowing you to easily shift into first gear or reverse without grinding gears. The clutch brake is not necessary when shifting into other gears while in motion.

CAUTION Be careful not to apply the clutch brake while the vehicle is moving. The purpose of the clutch brake is to stop the transmission so that you can shift into a starting gear without grinding gears. Applying the clutch brake when the vehicle is moving causes a braking effect on the drivetrain and shortens the service life of the clutch brake. If the clutch pedal is pressed completely to the floor and the transmission is not shifting, then it is time to have the clutch adjusted or serviced. Operating Manual Transmissions Follow these instructions if the vehicle has a manual transmission.

CAUTION If the transmission has a butt-tooth condition and you cannot engage a gear, gradually release the clutch. Then the drive gear can roll enough to allow the teeth to line up properly and complete the shift. The transmission shift pattern for your vehicle may be located on the shift control knob. In addition to understanding the shift pattern and its location, you should read the transmission manufacturer’s manual provided with your vehicle before operating the vehicle. After making sure the vehicle's Do not push the clutch pedal completely to the floor when shifting while the vehicle is in motion.

using the clutch brake while shifting a vehicle in motion will damage the clutch The clutch is not a footrest. Do not drive with your foot resting on the clutch pedal. It Y53-6096-1A1 (01/17) 103