DRIVING - Brakes Parking brakes work in reverse action of the regular brakes. When the parking brakes are engaged, air is exhausted from the spring chambers, which allows the spring to engage the brakes. This design also provides a safety function if a brake circuit has a leak and loses air. In such a scenario, the parking brakes will apply. Low Air Alarm on page 30 Anti-Lock Brake Systems (ABS) Automatic Traction Control Information on using the anti-lock brake system. General information on ABS and automatic traction control. This vehicle may be equipped with an anti- lock braking system (ABS). This ABS reduces the possibility of wheel lock-up.
If a wheel is about to lock during braking, the ABS will automatically adjust air pressure to the brake chambers on the appropriate wheel(s) to prevent wheel lock-up. The ABS is automatically turned on when the ignition switch is turned on. The vehicle’s parking brake controls are the yellow diamond shaped knob on your dash board. If the vehicle is equipped to tow a trailer, then there will be an additional red octagon shaped knob for the trailer parking brakes. Parking brakes will be engaged when either of these knobs are pulled OUT. (If one knob is pulled out, the other knob will automatically pop out.) 4 Your truck/tractor ABS is equipped with an automatic traction control (ATC) feature.
This feature is controlled by a switch on the dash. Do not allow the traction control lamp to remain on continuously for an extended length of time. Extended continuous use of the ATC can cause overheating of the drive wheel brakes. Engine torque or vehicle speed should be reduced to eliminate wheel spin and prevent excessive application of the ATC system. Except for checking for proper illumination of the ABS and traction control warning lamps when first starting the vehicle, and for monitoring these lamps while driving, no special operating procedures are required. For detailed system description, see literature for your specific ABS that was provided with your vehicle. WARNING!
Pushing IN a knob will disengage the respective parking brakes. If you push in the yellow knob only, you will disengage the vehicle’s parking brakes but will not disengage the trailer parking brakes (if applicable). Either knob will pop back out if the system pressure is not above 60 psi (414 kPa). The instrument panel display will provide a message any time the parking brakes (vehicle or the trailer) are set and the vehicle is put into motion. The Anti-Lock Brake System is a critical ve- hicle safety system.
For the safety of you and others around you, have the vehicle submitted for periodic preventive mainte- nance checks as well as having any sus- pected problems immediately checked by an authorized dealer. Failure to properly maintain your brake system can lead to seri- ous accidents. Failure to comply may result in death, personal injury, equipment or prop- erty damage. See Also Y53-6096-1A1 (01/17) 107