DRIVING - Brakes Auxiliary Transmission Compressed air is delivered to the brake system through the valve at the brake pedal and is controlled with various valves and braking circuits. The brake system is designed with separate front, rear and (when applicable) trailer circuits so that if one circuit is compromised and loses air, the other circuits will not be affected. Safety valves in each circuit will protect the other circuits in the event that a circuit loses air. Certain conditions may result in your brake surfaces becoming overheated (above 800°F or 427°C). Overheated brakes will damage linings and drum surfaces, ultimately decreasing braking performance.
Refer to Retarders and Descending a grade to avoid overheating the brakes. Information about using the auxiliary transmission. If you have an auxiliary transmission, see your transmission manufacturer’s manual for its proper operation. Parking Brake 4 Brakes Air Brake System The air compressor on the engine will typically provide 100-130 psi (690-896 kPa) to the air tanks. The vehicle is also designed with an air dryer, which removes moisture from the compressed air in order to protect all components in the air system. 1 This vehicle’s brake system functions with the use of compressed air generated from the engine’s air compressor.
The compressed air is stored in various air tanks to ensure that air pressure is available whenever the driver needs it. The brake system may be further enhanced by additional devices such as brake proportioning valves, Anti-lock braking systems or sensors designed to let you know if your brake pads need to be serviced. Certain conditions may result in the brake surfaces getting wet. Brake surfaces that are wet do not perform as well as when they are dry. There may be situations where wet brake surfaces cannot be avoided. In such situations, apply the brakes while in motion, to dry the brake surfaces. 2 WARNING!
3 Do not drive through water deep enough to wet brake components, as it may cause the brakes to work less efficiently than normal. The vehicle's stopping distance may be lon- ger than expected, and the vehicle may pull to the left or right when brakes are applied, which could contribute to an accident involv- ing death or personal injury. 1. Normal Run Position 2. Trailer Park with Vehicle Released 3. System Park or Trailer Charge with Vehicle Parked 106 Y53-6096-1A1 (01/17)