DRIVING - Axle and Suspension Perform this procedure at or near a weight scale. Procedure can be performed while parked on the weight scale if scale is available. To obtain the desired axle load distribution, you must correlate the suspension air gauge pressure to the actual axle load by scaling the axle weight(s) and adjusting the pressure to obtain the desired load. Once the desired load or load range is achieved, document the pressure-to-load ratio or setting for future use. NOTE the calibration of the auxiliary axles. If tires are installed with a different loaded radius, the calibration procedure must be repeated. Failure to do so can cause equipment dam- age.
Axle Creep ratings MUST NOT be exceed- ed. Contact your dealer or axle manufacturer to determine what the creep rating is for your particular axle(s) and configuration. Creep ratings are generally limited to the following: CAUTION Always lower the axles as soon as possible after receiving a load. Never exceed 5 miles per hour when driving with a load with the auxiliary axle(s) raised/unloaded. Failure to lower the axle(s) can overload the frame and remaining axles, and could cause equipment damage.
4 Tandem rear axles only Straight trucks only Maximum spring mount centers per axle manufacturers specifications Maximum tire static loaded radius (SLR) per axle manufacturers specifications NOTE This procedure must be performed prior to placing the vehicle into service. CAUTION Add: Perform this procedure at or near a weight scale. Procedure can be performed while parked on the weight scale if scale is available. Do not modify the air system and/or control functionality on a factory installed auxiliary axle(s). Modifying the factory operation of the pusher and/or tag axle(s) will void your warranty, and can cause equipment dam- age.
See Also Vehicle Loading on page 24 Pusher or Tag Suspension Calibration Setting the Pressure- to-Load Ratio To obtain the desired axle load distribution, you must correlate the suspension air gauge pressure to the actual axle load by scaling the axle weight(s) and adjusting the pressure to CAUTION Calibrating the suspension is important to ensure that the correct axle loads meet weight limits and obtain the proper load distribution. A change in tire size on either the auxiliary axles or the drive/steer axles can change Y53-6096-1A1 (01/17) 119