DRIVING - Axle and Suspension obtain the desired load. Once the desired load or load range is achieved, document the pressure-to- load ratio or setting for future use. achieving an estimated ground load). 5. After setting the pressure to obtain the desired axle load, verify proper ground loading with the weight scale. not be altered. Incorrectly adjusted ride height may result in improper interaxle U- joint working angles. This can result in pre- mature driveline wear and driveline vibration. If it becomes necessary to reset the ride height, you may temporarily set it by following the next procedure. Proper ride height measurement and values are shown in the illustration and table below.
These instructions are general in nature. For more specific instructions, review the pusher or tag suspension manufacturers maintenance manual or contact the nearest authorized dealer. NOTE 4 Exceeding local, state or federal weight lim- its may result in citations. Contact your local commercial weight enforcement office for limits in your area. CAUTION 1. Park loaded vehicle on level surface with wheels blocked. 2. Release vehicles spring brakes. (Do not release for Liftable/Non- Steerable pusher or tag axles). 3. Lower the pusher/tag axles with the axle lift control flip valve. (For some non-liftable axles, inflate air suspension). 4.
Adjust the amount of load on each axle by turning the pressure regulator clockwise to increase the load or counterclockwise to decrease the load. (The suspension manufacturer may publish pre- established Pressure-to-Load Ratio Pressure Settings to assist you in Completing this procedure will enable you to safely reach the nearest authorized dealer or repair facility to have ride height and pin- ion angle reset using the proper equipment and technique. Do this as soon as possible to avoid potential driveline damage. NOTE Steerable-pusher and/or tag axle(s) will raise when the transmission is shifted into reverse or when the parking brakes are ap- plied.
Air Suspension Ride Height NOTE Information on air suspension and adjusting the ride height. Suitable wheel chocks are at a minimum an 18-inch (46 cm) long 4x4. Vehicles equipped with rear or front air suspensions have their ride height and axle (pinion) angle(s) preset at the factory. These are precision settings and should 1. Park the vehicle, engage the parking brakes and clock the wheels. 120 Y53-6096-1A1 (01/17)