PACCAR 520 — Maintenance Schedule

MAINTENANCE - Maintenance Schedule 5 138 Y53-6096-1A1 (01/17) System Component Task I A B C D E Drive Axle (Meritor City Delivery / OFF HIGHWAY) Axle Housing Check the "cold" fill level at the differential carrier plug for a pinion angle of less than 7 degrees, or at the axle bowl plug for a pinion angle of greater than 7 degrees. Tighten the plug to 35-50 lb-ft (47-68 Nm) • Visually inspect for damage or leaks. • Drain and replace the lubricant. See Rear Axle Lubrication on page 203 Lubricant Filter Change the filter • Breather Check the operation. If the cap doesn’t rotate freely, replace. • Input Shaft and Pinion Shaft Check and adjust the endplay.

• Axle Shaft Tighten the rear axle flange nuts to the specified torque value. • Interaxle Differential Check the operation. • Drive Axle (SISU) Axle Housing Change the oil in the differential carrier and the hubs, and clean the magnetic oil drain plugs. • • Check the wheel bearing hubs and adjust if necessary. • • Visually inspect for damage or leaks. • • Check the oil level in the differential carrier and hubs. • Breather Check the breather for proper operation. • Lube Filter Clean the suction filter for the optional pressure lubrication system. • S-cam Brakes Overhaul the brakes: degrease all moving parts, check the bushings and seals for wear. •