MAINTENANCE - Air Tanks dryer replacement should be made with an identical component. Standards (FMVSS 121 - Air Brake Systems). As the Warning above states, any other type of air dryer installed in the place of an AD-IS Series will require changes, modifications and/or additions to your vehicle’s air system to maintain compliance with FMVSS 121. CAUTION WARNING! Do not use penetrating oil, brake fluid, or wax-based oils in the air system. These flu- ids may cause severe damage to air system components.
Use of an air dryer brand or model that dif- fers from what was originally installed could cause the air system to not perform correct- ly unless the full air system design is re- viewed and modifications are made to com- ply with Federal Motor Vehicle Safety Stand- ard (FMVSS) 121 Air Brake Systems. Fail- ure to abide by this warning and maintain compliance with FMVSS 121 could cause loss of vehicle control and may lead to death or serious personal injury. Air Tanks 5 Air tanks on the vehicle act as a reservior for the air system to use without running the air compressor all of the time. These air tanks require maintenance to keep them operational.
The AD-IS Series air dryer has incorporated into its design various components that have typically been installed separately on the vehicle (see below for components/areas affected): WARNING! If the supply and service air tanks are not drained at the recommended frequency, wa- ter could enter the air lines and valves. This could cause corrosion or blockage, which could compromise the brake system safety and potentially cause an accident. Failure to comply may result in death, personal injury, equipment or property damage. To eject moisture from the air system tanks, pull the line that is connected to the moisture ejection valve. Continue pulling until the air comes out free of water.
Pressure protection valves Safety valve Governor and plumbing Plumbing of the front and rear service air tanks Plumbing to accessory systems Daily The supply and service air tanks, must be drained on a daily basis. Operate air devices daily to circulate lubricants within the unit. These components are required to meet the Federal Motor Vehicle Safety 158 Y53-6096-1A1 (01/17)