MAINTENANCE - How to Check for Air System Leaks Periodically These tests should determine where air is escaping. Clean filter screens ahead of the valves by removing the screens and soaking them in solvent. Blow them dry with pressurized air before reinstalling them. dealer (or any other properly equipped serv- ice center) if a leak is detected. Failure to check the brakes or follow these procedures could cause a system failure, increasing the risk of an accident and may result in death, personal injury,equipment or property dam- age. What is an Air Compressor? Maintain the air compressor to prevent excessive oil bypass. Replace worn seals in valves and air motors as they are needed.
Your authorized dealer carries rebuild kits for most units. 1. Build up air pressure in the system to the governor cutout point or until 120 psi (827 kPa) is reached. 2. Stop the engine and release the service brakes. 3. Without applying the brake pedal, observe the rate of air pressure drop. This rate should not exceed 2.0 psi (14 kPa) per minute. 4. Start the engine and build up the air pressure again. 5. Stop the engine, and apply the brakes fully. Apply the brake pedal and hold it down for five minutes. The pressure drop should not exceed 3.0 psi (21 kPa) per minute. 6.
If you detect excessive leakage (air pressure loss greater than 3.0 psi (21 kPa) after five minutes of brake application), a leakage test should be made at the air line connections and at all air brake control units. Air systems have an air compressor that provides compressed air to the system. All compressors, regardless of make or model, run continuously while the engine is running. System pressure is controlled by the governor. The governor acts in conjunction with the unloading mechanism in the compressor cylinder block to start and stop compression of air.
The compressor is unloaded when the system pressure reaches 120 psi (827 kPa) and compression is reestablished when system pressure falls to 100 psi (690 kPa). 5 How to Check for Air System Leaks Use these steps if the air gauges in the dash or any warning lights turn on that indicate that a air leak exists in the system. Checking for air leaks should also be done after any service or repair has been done to the air system. Preventive Maintenance The following service checks are provided for your information only and should be performed by a certified mechanic. Contact your dealer or the engine manufacturer's Maintenance Manual for further information on servicing air compressors.
After completing any repairs to the air system, WARNING! Do not operate the vehicle if leakage in the air system is detected. Conduct the follow- ing procedure and contact an authorized Y53-6096-1A1 (01/17) 159