MAINTENANCE - Cooling System Maintenance provides freezing and boiling point protection. low all requirements listed in the engine manufacturers owner’s manual. NOTE WARNING! NOTE Maximum recommended ELC concentration is 60% ELC and 40% water by volume (a 60/40 coolant mixture). The minimum rec- ommended concentration is 40%. Coolant is toxic. DO NOT get the fluid in eyes. If contact occurs, flood eyes with large amounts of water for 15 minutes. Avoid pro- longed or repeated contact with skin. In case of contact, immediately wash skin with soap and water. DO NOT take internally. If swallowed, seek immediate medical atten- tion. DO NOT induce vomiting.
Failure to comply may result in death, personal injury, equipment or property damage. Coolant is harmful to the environment. Un- used coolant must be stored as a toxic haz- ardous material in leakproof containers. Used coolant must be processed as indus- trial chemical waste. Please follow HAZMAT guidelines with both used and unused cool- ants. Condition Perform a visual inspection of the ELC. It should have no cloudiness or floating debris. Determine the chemical inhibitor concentration level by using an ELC- specific test kit or test strips. Inhibitor concentration level determines corrosion protection.
If you are concerned about possible coolant quality, contamination, or mechanical problems, submit a coolant sample for analysis. Improper maintenance may cause coolant degradation and could result in damage to the cooling system and engine components. Consult your dealer or the ELC manufacturer’s representative for recommended ELC test kits, test strips, and laboratory sample procedures. 5 Concentration CAUTION Check the level of freeze/boilover protection, which is determined by the ELC concentration. Use a glycol refractometer to determine glycol level. Add ELC to obtain the ELC/water ratio required to provide the protection you need.
A 50/50 mix of ELC and water is adequate for most applications. For extremely cold operating conditions, the ratio can be adjusted to a higher concentration of ELC. The engine cooling system has very specific maintenance and inspection requirements. Failure to follow requirements can damage the engine. Engine damage can include but is not limited to freezing, boiling, corrosion, pitted cylinder liners. This information is found in the engine manufacturers owner’s manual. It is the owner’s responsibility to fol- In an ELC-filled cooling system, the freeze point should be maintained between -30° F and -45° F (-34° C and -43° C). Y53-6096-1A1 (01/17) 169