MAINTENANCE - Cooling System Maintenance 1. Fill Cap 2. Sight Glass How to Add Coolant to the Cooling System WARNING! Removing the fill cap on a hot engine can cause scalding coolant to spray out and burn you badly. If the engine has been in operation within the previous 30 minutes, be very careful in removing the fill cap. Protect face, hands, and arms against escaping flu- id and steam by covering the cap with a large, thick rag. DO NOT try to remove it un- til the surge tank cools down or if you see any steam or coolant escaping. In any situa- tion, remove the cap very slowly and care- fully. Be ready to back off if any steam or coolant begins to escape.
Inspect Coolant Level Add coolant through the surge tank fill cap. Do not remove the pressure cap to fill the cooling system. Top off coolant when the level in the surge tank is below the sight glass on the side of the tank. Coolant is added through the pressure cap fill neck. WARNING! Do not remove the radiator fill cap while the engine is hot. Scalding steam and fluid un- der pressure may escape. You could be badly burned. Failure to comply may result in death or personal injury. 5 NOTE If frequent topping off is necessary and there are no visible signs of coolant leaks when the engine is cold, check for leaks with the engine operating at normal temper- ature. NOTE 1. Fill Cap 2.
Sight Glass See Also Engine is Overheating on page 31 Do not use the pressure cap to fill the surge tank with fluid. 172 Y53-6096-1A1 (01/17)