PACCAR 520 — Safety Restraint System - Inspection

MAINTENANCE - Safety Restraint System - Inspection tank. Continue to fill the surge tank until the coolant level remains approximately Ѕ in. above the "MIN" line. This may take up to 2 minutes, depending on the outside temperature. 8. Operate the engine throttle until the operating temperature stabilizes (when the thermostat opens). 9. Fill the surge tank as necessary to raise the coolant level to Ѕ in. above the "MIN" level. 10. Operate the engine at high idle for another 10 minutes and then fill the surge tank again to Ѕ" above the "MIN" level. 11. Replace the surge tank fill cap. percent concentration of antifreeze, as a shortened heater life will result.

NOTE Do not overfill a cooling system. Excess coolant may result in overflow, loss of anti- freeze, and reduced corrosion protection. After servicing the cooling system, operate the vehicle for a day or two before using the heater. Trapped air inside the engine needs time to escape. 1. If your cooling system is built with drain valves in the upper engine coolant pipe, open them before filling the surge tank. 2. Close any open coolant drains in the system. 3. Remove the surge tank fill cap (do not remove the surge tank pressure cap). 4. Fill the system with premixed coolant through the surge tank fill cap.

Pour coolant at a steady flow rate until the surge tank is full (to the base of the fill neck). It may be necessary to pause for 1 minute and then re-fill if the fluid level dropped. 5. Close any drain valves that were opened in Step 1. 6. Start the engine and idle at low rpm. 7. During low rpm idle, air will purge from the cooling system which will lower the coolant level in the surge Safety Restraint System - Inspection The seat belt system, including webbing, buckles, latches, and mounting hardware, endures heavy use in heavy-duty vehicles, much more than seat belt systems in passenger cars. All users should be aware of the factors contributing to this heavy use and reduced belt life.

5 Check the coolant level after each trip. Add coolant as necessary. You may find your coolant level is not up to the correct level soon after you have filled the radiator. This may be because all the trapped air in the system has not yet been purged. It takes a little time for all of the air to leave the system after you fill your radiator. WARNING! Failure to properly inspect and maintain re- straint systems can lead to injury or loss of life. Without periodic inspection and mainte- nance to detect unsafe conditions, seat re- straint components can wear out or not pro- tect you in an accident. Use a solution of half ethylene glycol antifreeze and half water for best heater performance.

Do not use more than 65 Y53-6096-1A1 (01/17) 173