PACCAR 520 — Safety Restraint System - Inspection

MAINTENANCE - Safety Restraint System - Inspection 2. Web cut or frayed at D-loop web guide. 3. Comfort Clip cracked or damaged. 4. Buckle casting broken. 5. Retractor Web Storage for damage. (located behind trim panel) 6. Tethers for web wear and proper tightness of mounting hardware. 7. Mounting hardware for corrosion, proper tightness of bolts and nuts. 8. Web for deterioration, due to exposure to the sun. Environmental conditions, such as dirt and ultraviolet rays from the sun, will reduce the life of the seat belt system. WARNING! It is important to remember that any time a vehicle is involved in an accident, the entire seat belt system must be replaced.

Unex- posed damage caused by the stress of an accident could prevent the system from functioning properly the next time it is need- ed. Failure to comply may result in death or personal injury. Due to these factors, the three-point safety belt system installed in your vehicle requires thorough inspection every 20,000 miles (32,000 km). If the vehicle is exposed to severe environmental or working conditions, more frequent inspections may be necessary.

Any seat belt system that shows cuts, fraying, extreme or unusual wear, significant discoloration due to UV (ultraviolet) exposure, abrasion to the seat belt webbing, or damage to the buckle, latch plate, retractor hardware or any other obvious problem should be replaced immediately, regardless of mileage. 5 Seat Belt Inspection Points Factors contributing to reduced seat belt life: Heavy trucks typically accumulate twice as many miles as the average passenger car in a given time period. Seat and cab movement in trucks causes almost constant movement of the belt due to ride characteristics and seat design.

The constant movement of the belt inside the restraint hardware and the potential for the belt to come in contact with the cab and other vehicle parts, contributes to the wear of the entire system. Inspection Guidelines Follow these guidelines when inspecting for cuts, fraying, extreme or unusual wear of the webbing, and damage to the buckle, retractor, hardware, or other factors. Damage to these areas indicates that belt system replacement is necessary. 1. Web cut or frayed or extremely worn at latch area. 174 Y53-6096-1A1 (01/17)