PACCAR 520 — Install Engine Belt

MAINTENANCE - Engine Maintenance 5. Place the dipstick back into the holder. 6. Pull the dipstick out again and check the oil level. The oil level should always be between the 2 marks on the dipstick. Engine, Oil Temperature on page 62 Engine, Oil Pressure on page 62 replacement, please see engine Operator’s Manual included with this chassis. 2. After topping up, wait 1 minute and check the oil level again. 3. Reinstall the oil fill cap and twist to lock it in place. Topping Up the Engine Oil Engine Oil Dip Stick Markings Install Engine Belt You can extend the reliability and service life of your vehicle's drive belts with proper attention to installation, and maintenance.

Neglect could cause belt failure. The result could be the loss of the electrical or air system as well as possible engine damage from overheating. So it's a very good idea to check your belts frequently and replace them as soon as you detect trouble. 5 1 2 NOTE See the engine manufacturer's operator's manual for further information on replacing engine drive belts. 1. High oil level (1) 2. Low oil level (2) Follow this procedure to install an accessory drive belt: 7. Reinstall the dipstick and twist to lock it in place. 1. Top up with oil, if necessary, via the filler opening. Use the correct grade in the correct quantity. For oil 1.

Route the new belt around the pulleys, and then rotate the See Also 188 Y53-6096-1A1 (01/17)