MAINTENANCE - Engine Maintenance automatic tensioner so that the idler pulley swings toward the belt routing. The following figure shows an example of the rotation direction to release the tensioner. WARNING! Do not work on or near the fan with the en- gine running. Anyone near the engine fan when it turns on could be injured. If it is set at MANUAL, the fan will turn on any time the ignition key switch is turned to the ON posi- tion. In AUTO, it could engage suddenly without warning. Before turning on the igni- tion or switching from AUTO to MANUAL, be sure no workers are near the fan. Failure to comply may result in death or personal in- jury.
5 Your truck may be equipped with an On/Off or Viscous Fan Drive. Follow these guidelines to check your engine fan: 2. Slip the belt around the idler pulley attached to the automatic tensioner. 3. Release the automatic tensioner. 4. Check the belt alignment on each pulley. The belt must fall between the flanges of each pulley. Check the fan bearings for fan hub bearing looseness, loss of lubricant and any abnormal conditions. (For example, fan belt misaligned or excessive wear/damage.) Before starting the engine and with the engine off, look and feel for looseness in the fan hub. With the engine idling and the hood open, stand at the front of the vehicle.
Listen for any noises coming from the fan hub. Bearings that have lost lubricant, and are dry, Engine Fan General maintenance information and precautions about the engine fan. Y53-6096-1A1 (01/17) 189