PACCAR 520 — Turbocharger

MAINTENANCE - Engine Maintenance will typically emit a squeal or a growl when the engine is at operating temperature and the fan clutch is engaged. If noise is detected, have the fan bearings inspected by an authorized dealership. the intake system allow abrasive dust to enter the engine and quickly cause expensive damage. During your daily walk- around inspection, carefully check all tubing, elbows, clamps, supports and fasteners for condition and tightness. WARNING! Do not operate engine with turbocharger in- take piping disconnected. A suction is creat- ed when the engine is running. This suction could draw your hand or anything else near it into the impeller fan. You could be injured.

Always keep the intake piping connected when you will be running the engine. Engine Fan Blade Verify that there is enough fan blade clearance with the fan shroud. Around the fan shroud, the recommended distance is 1 in. (25 mm) from front edge of any fan blade-to-radiator side member. Minimum clearance is 3/4 in. (19 mm). Check the Charge-Air-Cooler for air leaks annually. The air leaks can be caused by cracked tubes or header. For service see your authorized dealer. When servicing the air intake and exhaust systems on a turbocharged engine, check the items listed below: 5 CAUTION Rear edge of any blade must be no closer than 3/8 in. (9 mm) to the nearest engine component.

If this cannot be obtained, the fan spacer or fan is not correct. The leading edge of any fan blade must be 1 in. (25 mm) from the inside edge of the shroud. Do not use air intake pipes and connections as a step or to pull yourself up. This could loosen the connections and open the sys- tem to unfiltered air which could damage the engine. Lubricating System Check the oil lines, housing, and connections. Look for leaks, damage, or deterioration. Leaks could mean you have damaged oil lines or oil seals. See Also Pipe and Hose Clamp Torque Values on page 221 Manifold With the engine operating, check for leaking manifold or flange gaskets.

Air Intake System Turbocharger High Frequency Vibration General information and precautions on how to maintain the air intake system. General information about maintaining the turbocharger. Vibration may indicate turbo rotor imbalance. Have your dealer investigate this immediately. If you detect any deficiencies, take the vehicle to an authorized dealer for servicing. Delay could Engine heat, vibration, and age combine to loosen air intake connections and cause cracks in the tubing and elbows. Leaks in 190 Y53-6096-1A1 (01/17)