PACCAR 520 — Inspecting Noise and Emission Components

MAINTENANCE - Noise and Emission Control Removing or rendering engine speed governor inoperative so as to allow engine speed to exceed manufacturer's specifications. Modifying ECU parameters. Exhaust System Removing noise insulators from engine block or from around the oil pan. Cutting holes in, or cutting away part of noise insulators. Removing hood-mounted noise insulation. Check the induction tubing, elbow connections, clamps, brackets, and fasteners for deterioration, cracks, and security. If you find an air leak anywhere between the air cleaner and the engine, repair that leak immediately. Removing or rendering inoperative exhaust system components.

Fuel System Inspecting Noise and Emission Components CAUTION 5 Removing or rendering engine speed governor inoperative, allowing engine speed to exceed manufacturer's specifications. Removing of air signal attenuator on engines equipped with this device. Removing of diesel exhaust fluid tank and system. Inner Fender Shields and Cab Skirts If, during periodic inspection and maintenance of other systems and components, it is found that parts of the noise control system require attention, we recommend that those parts be inspected at more frequent intervals to assure adequate maintenance and performance. Air leaks cause excessive noise and may result in serious damage to the engine.

If you do not repair them the engine damage will not be covered by your warranty. Repair all air leaks as soon as you find them. Engine Mounted Noise Insulators The following instructions are based on inspection of the noise control system at regular intervals as indicated in the Noise Control System - Maintenance Log on page 219. Check condition. Is the insulator secure? How you do this will depend on the method of attaching the noise insulators on the engine and around the oil pan (bolts, snap fasteners, or straps). Tighten loose fasteners and repair or replace any worn or damaged fasteners.

Check insulators around fasteners and stress points, especially where they may be affected by engine vibration. Repair any cracked or damaged mounting points. Use Air Intake System Removing shield or skirts. Cutting away parts of shields, skirts or damaged or loose portions of shields or skirts. Noise Insulating Blankets Do all checks and maintenance procedures listed in this manual under Engine Air Intake System and Air Cleaner. 200 Y53-6096-1A1 (01/17)