MAINTENANCE - Rear Axle and Suspension suitable reinforcing plates to ensure that the insulators will remain in position. Check exhaust piping for rust, corrosion, or damage. Replace deteriorated piping before holes appear. If piping is perforated at any point, temporary patching or lagging is acceptable until you can have permanent repairs made. On turbocharged engines, check joints at flanges and mounting brackets for tightness. Hood Insulation Blanket Inner Fenders Shields and Cab Skirts Exhaust System Rear Axle and Suspension Check for exhaust leaks, which would indicate a leaking manifold gasket; replace gasket if necessary.
Check cap screws for tightness, including those at the flanges. Refer to the engine manufacturer's service manual for proper tightening sequence and torque values. Maintenance requirements for rear axle suspension. Diesel Particulate Filter (DPF) Your vehicle's suspension, by design, requires a minimal amount of maintenance. However, suspensions in over-the-road operations require periodic inspection to ensure trouble-free performance. Check diesel particulate filter (DPF), clamps, and mounting brackets. Tighten if necessary. Inspect diesel particulate filter (DPF) for signs of rust or corrosion. Check internal baffling.
You can do this by listening for rattling sounds while tapping on the diesel particulate filter (DPF) with a rubber mallet or revving the engine up and down through its normal operating range. 5 Joints and Clamps Check for leaks, and tighten as necessary. Check for deterioration or dents in pipes and clamps which could allow exhaust to escape. Replace any serviceable joints, flexible pipes and gaskets at the service intervals. WARNING! Do not work on the vehicle without the park- ing brake set and wheels blocked securely. If the vehicle is not secured to prevent un- controlled vehicle movement, it could roll and may result in death, personal injury, equipment or property damage.
Selective Catalysts Reduction (SCR) Check SCR canister filter, clamps and mounting brackets. Tighten if necessary. Inspect SCR canister for signs of rust or corrosion. Diesel Exhaust Fluid Tank (See Aftertreatment System manual.) Exhaust Tail Pipe Engine Fan and Shroud Exhaust Piping Y53-6096-1A1 (01/17) 201