PACCAR 520 — Rear Axle and Suspension

MAINTENANCE - Rear Axle and Suspension inspect the suspension periodically, as noted below: WARNING! CAUTION Do not operate the vehicle if the suspension U bolts are not properly tightened. Loose U bolts will cause the axle to not be properly secured to the suspension, which could cause loss of vehicle control and an acci- dent. Loose U bolts can also cause uneven tire wear and poor alignment. Failure to comply may result in death, personal injury, equipment or property damage. Do not spray the suspension with chemical products or mineral oil; it can cause damage to the bushings. Visually check for loose or missing fasteners, cracks in hanger, or axle connection brackets.

Check that springs are centered in hangers and in good condition. Check for cracks, wear marks, splits, or other defects on the surface of the spring. Replace defective parts. Because repaired springs cannot be fully restored to their original service life, replace the complete assembly if cracks or other defects are detected. After replacement of any part or discovery of loose components, check the torque of all fasteners. New springs settle-in after the vehicle's initial service, causing the U-bolts to become loose. NOTE Failure to follow these recommendations could void warranty. 5 WARNING!

For all vehicles, mandatory maintenance procedures include retightening of U-bolts and complete inspection. However, even with proper maintenance, many factors affect the service life of springs and suspension components, such as: fatigue, vehicle gross weight, type of load, road conditions, and vehicle speed. It is important that U-bolts remain tight. Severe use of your vehicle can cause them to loosen faster. But all vehicles need to have their U-bolts checked and tightened regularly. Be sure someone with the proper training and the right tools checks and tightens the U-bolts on your vehicle.

After the first 500 miles (800 km) of operation, Visual Inspection Failure to maintain the specified torque val- ues or to replace worn parts can cause component system failure, possibly resulting in an accident. Improperly tightened (loose) suspension U bolts can lead to unsafe vehi- cle conditions, including: hard steering, axle misalignment, spring breakage or abnormal tire wear. Failure to comply may result in death, personal injury, equipment or proper- ty damage. Rear Suspension Fasteners To maintain the performance of the air suspension, check fastener torque values after the first 2,000 miles (3,218 km) of service and every 60,000 miles (96,000 km) thereafter.

Torque recommendations apply to fasteners supplied and installed by 202 Y53-6096-1A1 (01/17)