MAINTENANCE - Rear Axle and Suspension vehicle manufacture. The values listed in the at the back of this chapter (Specification Reference Charts), are for cadmium plated or phosphate and oil fasteners only. U-bolts are difficult to tighten unless you have the right equipment. If you cannot tighten them correctly yourself, be sure to have them checked and tightened regularly by an authorized mechanic. Rear Axle Lubrication NOTE Lubrication requirements for rear axles. Whenever possible, torque all frame fasten- ers on the nut end, not the bolt head. See the axle manufacturer's operator's manual for lubrication specifications and service intervals.
Load the vehicle to its normal gross weight before tightening U-bolts. Loading the vehicle ensures proper adjustment of the U-bolt and spring assembly. Check oil level with the vehicle parked on level ground and the fluid warm. The level should be even with the bottom of the filler hole. Rear Suspension U-Bolts WARNING! Rear Axle Alignment 5 NOTE Do not replace U bolts and nuts with com- mon U bolts or standard nuts. These parts are critical to vehicle safety. If the wrong U bolts or nuts are used, the axle could loosen or separate from the vehicle and cause a serious accident. Use only U bolts and nuts of SAE Grade 8 specification or better.
Fail- ure to comply may result in death, personal injury, equipment or property damage. Continual road shock and load stresses may force the rear axles out of alignment. If you detect rapid tire wear on the rear axles, you may have misaligned axles. If you suspect rapid tire wear, have your rear axle alignment checked and adjusted by an authorized dealer. To ensure an accurate torque reading, use properly maintained and calibrated torque wrenches. Clean the nut and bolt. No dirt, grit, or rust should be present. WARNING! Do not operate the vehicle if the suspension U bolts are not properly tightened.
Loose U bolts will cause the axle to not be properly secured to the suspension, which could cause loss of vehicle control and an acci- dent. Loose U bolts can also cause uneven tire wear and poor alignment. Failure to comply may result in death, personal injury, equipment or property damage. See Also Suspension U-Bolts, Grade 8 on page 213 Wheel Cap Nut Torque Specifications on page 215 Frame Fastener Torque Requirements on page 214 Suspension U-Bolts, Grade 8 on page 213 Suspension alignment should be checked when any one of the following conditions exist: Discovery of loose suspension fasteners.
(Loose, defined as any torque below the recommended torque value.) Discovery of elongated holes in a suspension component. Y53-6096-1A1 (01/17) 203