MAINTENANCE - Steering System Power Steering Fluid cold. Each of the conditions have a MAX and a MIN mark. 1. Park the vehicle and turn the engine off 2. Open the hood and locate the power steering filter housing 3. Open the housing by taking off the top of the housing 4. Replace the filter 5. Replace the fluid 6. When adding new fluid, bleed the power steering system by turning on the engine and turning the steering wheel full right and then full left. Add fluid when necessary as air bleeds out of the system. Have the power steering fluid and filters changed at an authorized dealer.
If you check the fluid with the engine and steering system COLD, the fluid level should be at/or above the Minimum indicator level and should generally not exceed the middle point between Maximum and Minimum level indicators. If you check the fluid with the engine and steering system WARM, the fluid should NOT exceed the Maximum level indicator and should generally not drop below the middle point between the Maximum and Minimum level indicators. CAUTION When adding fluid, be sure to use fluid of the same type. While many fluids have the same description and intended purpose, they should not be mixed due to incompati- ble additives. Mixing incompatible fluids may lead to equipment damage.
5 NOTE Before removing reservoir cover, wipe out- side of cover so that no dirt can fall into the reservoir. Check and completely change the fluid level. Use the following procedure: Power Steering Fluid Filter 1. Park the vehicle on level ground and turn the engine off. 2. Open hood 3. Open the fill cap to the power steering reservior. In addition to the reservoir itself, the cap has a dipstick that indicates fluid level when the fluid is hot and when it is The power steering system has a filter that needs to be maintained. CAUTION Servicing the power steering system without bleeding it of trapped air may cause dam- age to the power steering pump. Y53-6096-1A1 (01/17) 205