MAINTENANCE - Steering System Steering Shaft Bolt Torque Specifications Pitman Arm Clamp Bolt Fastener torque specifications for steering shaft. For off–highway vehicles, tighten the U– bolts after the first day or two of operation. Then check weekly. The following are common torque specifications for most steering shafts. 5 WARNING! Steering U-joint Pinch Bolt If this chassis is equipped with an electronic stability control (ESC) and is modified (e.g.
adding or removing an axle, converting from a truck to a tractor, converting from a tractor to a truck, changing the body, lengthening of the wheelbase and/or frame, relocating frame components, or modifying pneumatic or electrical ABS/ESC harnesses) the ESC must be disabled by a qualified technician. If you have any questions, contact your au- thorized dealer. Failure to comply may result in death, personal injury, equipment or prop- erty damage. 206 Y53-6096-1A1 (01/17) Fastener Size Tightening Specification ft- lb (N•m) 3/4 inch 300-320 (406-433) Fastener Size Tightening Specification ft- lb (N•m) 7/16 inch 55-60 (74-81)