EMERGENCY - Roadside Assistance 1. Remove any personal jewelry that may come in contact with the battery terminals. 2. Select a jumper cable that is long enough to attach to both vehicles in a way that ensures neither vehicle touches each other. 3. Position the two vehicles together, but do not allow them to touch. 4. Turn OFF all lights, heater, radio, and any other accessory on both vehicles. 5. Set the parking brakes: pull out the Yellow button located on the dash. See Air Brake System on page 106. 6. Shift the transmission into park position or neutral for manual transmissions. See Operating Manual Transmissions on page 103 and see Automatic and Automated Transmissions on page 105. 7.
If either vehicle is equipped with battery disconnects ensure they are in the OFF position prior to connecting the two vehicles. 8. Attach one end of a jumper cable to the positive (+) terminal of the discharged (dead) battery. This will WARNING! CAUTION Never remove or tamper with battery caps. Ignoring this could allow battery acid to con- tact eyes, skin, fabrics, or painted surfaces. Failure to comply may result in death, per- sonal injury, equipment or property damage. Applying a higher voltage booster battery will cause expensive damage to sensitive electronic components, such as relays, and the radio. Failure to comply may result in equipment damage. 2 WARNING!
CAUTION Never jump start a battery near fire, flames, or electrical sparks. Batteries generate ex- plosive gases that could explode. Keep sparks, flame, and lighted cigarettes away from batteries. Failure to comply may result in death, personal injury, equipment or prop- erty damage. Improper hook-up of jumper cables or not following these procedures can damage the alternator or cause seri ous damage to both vehicles. WARNING! WARNING! Heed all warnings and instructions of the jumper cable manufacturer. Failure to com- ply may result in death, personal injury, equipment or property damage.
When jump starting using a battery booster, it is best to jump start with an equivalently powered vehicle. Verify that the booster bat- tery has the same volt and cold cranking amperage specifications as the dead battery before attempting to jump start. Failure to comply may cause an explosion resulting in death, personal injury, equipment or proper- ty damage. Be careful that metal tools (or any metal in contact with the positive terminal) do not contact the positive battery terminal and any other metal on the vehicle at the same time. Remove metal jewelry and avoid leaning over the battery. Y53-6096-1A1 (01/17) 35