EMERGENCY - How to Recover a Vehicle 6. Ensure that the tow pin and lock clip are installed before using the hitch. 7. Remove the hitches and store all parts after recovering the vehicle. WARNING! to the vehicle may occur if rigging is not connected properly. Do not use parts from other trucks or materi- als from other sources to repair a hitch or to replace a missing hitch. The parts provided for recovery are made of high strength ma- terials and are specifically designed for vehi- cle recovery. Failure to use the correct facto- ry equipment may result in an accident in- volving death or personal injury.
CAUTION 2 When recovering ditched or bogged vehi- cles, stay well below Maximum Capacities. Even at loads below maximum, the physical strain of recovering a vehicle could damage axles, suspensions, fifth wheels, etc. How to Prepare the Axles for Towing If the vehicle is going to be towed from the front axle and using the rear axle for support, then the axle shafts should be prepared [removed] so that minimal damage is made to the differential during the towing process. CAUTION Use the following procedure to install the Vehicle Recovery Hitches. See Recovery Hitch Assembly illustration for part identification. Connect recovery rigging only to hitches in- tended for that purpose.
Do not attach to bumpers or brackets. Use only equipment designed for this purpose. Failure to comply may result in equipment damage. Ensure that the recovered vehicle does not have an open air line. An open air line on the recovered vehicle will cause a leak in the air system of the recovery vehicle if both vehicles’ brake systems are connected. This could cause a loss of system air, which can cause the service brakes not to function, resulting in the sudden application of the spring brakes causing wheel lock-up, loss of control, or overtake by following vehicles. 1. Check square sockets behind lower bumper for obstructions, clear if necessary. 2.
With lock pins removed, insert hitches through bumper and into the square hitch socket. 3. Align the hole in the tow hitch with the square hitch socket hole. 4. Insert the lock pin into the square hitch socket hole and through the hole in the tow hitch until the lock tab is within the square hitch socket. 5. Rotate the lock pin 90 degrees to secure the pin in place. How to use a Recovery Hitch CAUTION Recovery pull maximums assume the tow rigging evenly distributes the load between both recovery hitches. See examples in Re- covery Rigging for details. Serious damage Y53-6096-1A1 (01/17) 41