PACCAR 520 — How to Manually Lock a Differential

EMERGENCY - How to Recover a Vehicle not work when the engine is stop- ped. When vehicles are towed either by wrecker or piggyback, lubricant in the top front of the drive axle will drain to the rear. This will leave the top components dry, resulting in fric- tion that will seriously damage these components. Follow these procedures if the vehicle has a driver controlled differential lock. WARNING! 2 An open air line on the recovered vehicle will cause a leak in the air system of the re- covery vehicle if both vehicles’ brake sys- tems are connected.

This could cause a loss of system air, which can cause the service brakes not to function, resulting in the sudden application of the spring brakes causing wheel lock-up, loss of control, or overtake by following vehicles. You could be in an accident involving death or personal injury. Ensure that any air line that has been removed from a driver-controlled main differ- ential lock is firmly capped to prevent loss of air pressure from the recovery vehicle if it is supplying air pressure. This procedure should be done before the axle shafts are removed. CAUTION 2. If the vehicle has driver controlled differential lock, then manually lock the differential. 3. Remove drive axle shafts. 4.

Cover the open ends of the hubs to prevent dirt and debris from entering the axle. Failure to install the caging bolt when towing vehicles with driver-control main differential lock can result in damage by failing to lock internal components in position. WARNING! CAUTION An open air line on the recovered vehicle will cause a leak in the air system of the re- covery vehicle if both vehicles’ brake sys- tems are connected. This could cause a loss of system air, which can cause the service brakes not to function, resulting in the sudden application of the spring brakes causing wheel lock-up, loss of control, or overtake by following vehicles.

You could be in an accident involving death or personal injury. Ensure that any air line that has been removed from a driver-controlled main differ- ential lock is firmly capped to prevent loss of air pressure from the recovery vehicle if it is supplying air pressure. 1. Lift driving wheels off the ground or remove the driveline and axle shafts before towing the vehicle. Water, dirt and other material can enter an open hub or axle. This can contaminate the axle fluid and cause possible damage to components. Ensure that the hubs are covered with plastic whenever a drive axle shaft is removed.

CAUTION Failure to lift the driving wheels off the ground or remove the driveline and axle shafts before towing the vehicle could seriously damage your vehicle. All lubricating and clutch ap- plication oil pressure is provided by an engine-driven pump, which does How to Manually Lock a Differential Always lock the differential when the axles are being removed to aid in re-installation. 42 Y53-6096-1A1 (01/17)