CONTROLS - Guide to the Warning Symbols Illuminates during the power-on self- test when the ignition is turned ON. It turns off after a few seconds if no system problems are detected. If an ATC problem is detected, the ATC warning lamp will turn on and stay on. Illuminates when the ATC is regulating wheel spin and turns off after the traction control event has ended. Flashes continuously when the ATC/ Deep Snow & Mud switch is turned on, indicating that this feature is active. problem is detected, the ESC Warning lamp will turn on and stay on. Illuminates when the ESC system is regulating individual wheel brakes to correct the vehicle’s direction of travel.
(Refer to Advanced ABS with Stability Control for more information.) NOTE For more information about the stability con- trol system installed on your vehicle, please refer to additional material supplied with this operator manual, included in your glove box informational packet. 3 Axle, Stability Control WARNING! If this chassis is equipped with an electronic stability control (ESC) and is modified (e.g.
adding or removing an axle, converting from a truck to a tractor, converting from a tractor to a truck, changing the body, lengthening of the wheelbase and/or frame, relocating frame components, or modifying pneumatic or electrical ABS/ESC harnesses) the ESC must be disabled by a qualified technician. If you have any questions, contact your au- thorized dealer. Failure to comply may result in death, personal injury, equipment or prop- erty damage. WARNING! If this chassis is equipped with an electronic stability control (ESC) and is modified (e.g.
adding or removing an axle, converting from a truck to a tractor, converting from a tractor to a truck, changing the body, lengthening of the wheelbase and/or frame, relocating frame components, or modifying pneumatic or electrical ABS/ESC harnesses) the ESC must be disabled by a qualified technician. If you have any questions, contact your au- thorized dealer. Failure to comply may result in death, personal injury, equipment or prop- erty damage. Calculates the driver’s intended path of travel from wheel speed and steering angle sensors, then compares calculations to the actual direction of travel. The system uses individual wheel brakes to re-adjust the path of the vehicle.
The Stability Control Icon (ESC or Electronic Stability Control) illuminates during the power-on self test when the ignition is turned ON. It turns off after a few seconds if no system problems are detected. If a 58 Y53-6096-1A1 (01/17)