PACCAR 520 — How to Use the Turn Signal

CONTROLS - Dual Station Switch 3. Station Selector (for Dual Steer Applications) 4. Fog Lights 5. Mirror Control 6. Cab Lighting Dimmer Control 7. Differential Lock 8. Differential Lock 9. Lift Axle 10. Lift Axle 11. Lift Axle side of the cab cannot be used when right hand operation is in effect. Vehicle operation will revert back to the left hand drive position when the ignition is turned to the OFF position. How to Use the Turn Signal 3 The lever-action turn signal/high beam switch is located on the left side of the steering column. Each time a turn indicator is activated the buzzer emits a short beep. The ignition key must be turned to ON for the signal/switch to operate.

Steering Column Controls The turn signal lever is mounted on the left side of the steering column. The lever controls several functions: turn signal, high beam, and windshield wiper control. Dual Station Switch NOTE The dual station switch allows the controls for the vehicle from left hand to right hand operation. If the vehicle turn signals and turn signal in- dicators in the dash gauge cluster ever be- gin flashing at an accelerated rate (115 cy- cles per minute) when the turn signal lever is in the OFF (center) position, or when a Right/Left turn has been selected, the prob- lem may be related to a failed turn signal switch or turn signal module.

In either case, the problem is not a failed bulb. Contact your nearest authorized dealer to have the problem corrected as soon as possible. 1. Mulitfunction turn signal/wiper/ washer 2. City Horn 1. Push the lever up to engage the RIGHT turn signal and down to engage the LEFT turn signal. Pushing this switch will engage electronic switchs on the right hand side of the vehicle. Certain controls on the left hand 74 Y53-6096-1A1 (01/17)