CONTROLS - How to Turn on High Beams How to Turn on High Beams How to Momentarily Flash High Beams The high beam function is operated by the same steering column lever for the turn signals. High beams will not turn on if the headlights are turned off. The "flash to pass" high beam function is operated by the same steering column lever for the turn signals. The high beam flash to pass will work if the headlights are not on. 3 2. Release the signal stalk 3. The turn signal will cancel when the turn is complete. 1. Gently pull the turn signal lever, toward the steering wheel, until you hear the switch click and the beam changes.
Each time the turn indicator is activated the audible warning emits a short beep. 1. Gently push the turn signal lever, away from the steering wheel. WARNING! After you complete a turn, shut the system off by returning the lever to the "OFF" (cen- ter) position. Failure to shut off a turn signal could confuse other drivers and result in an injury accident. An indicator light in the in- strument panel will flash until the turn signal is turned off. 2. The lever will automatically return when the lever is released. 2. To return to previous beam: pull the lever towards the steering wheel again.
The blue indicator light in the instrument panel will momentarily turn ON and the high beams will flash. The high beams will not remain on if the lever is still pressed. The blue indicator light in the instrument panel will turn ON and the high beams will turn on. Y53-6096-1A1 (01/17) 75