DRIVING - Starting and Warming Up the engine still won’t start after a couple of tries, check the fuel lines for possible fuel starvation or air leaks. Starting failure may mean fuel isn’t reaching the injectors. 6. As soon as the engine starts, begin to watch the oil pressure gauge. Check your engine manufacturer’s manual for the right pressure for your engine. If the oil pressure doesn’t rise within a few seconds, stop the engine. Find out what is wrong before restarting the engine. 7. Slowly engage (release) the clutch after the engine has started. 8. Wait for the oil pressure gauge to reach normal operating pressure before operating the vehicle or idling faster than 1,000 rpm.
started within the 6 minute timeframe, the operator will have to re-enter the passcode to start the engine. properly grounded AC electrical source. Do not start the engine with the heater plugged in. Tips to Remember When Starting Vehicle in Cold Weather WARNING! In cold weather, fast engine starting helps relieve the loads on the electrical system and cranking motor. Using the special cold starting equipment will help starting. Engine block heaters can cause fires which may result in death, injury and/or property damage if not properly maintained and oper- ated. Regularly inspect the engine block heater wiring and connector for damaged or frayed wires.
Do not use the heater if there are any signs of problems. Contact your au- thorized dealer or the manufacturer of the heater if you are in need of repairs or infor- mation. 4 If you follow a few simple guidelines, you will extend the service life of your engine: Keep the electrical system in top condition. Use the best quality fuel of the recommended grade. Use recommended engine lubricating oil. For manual transmissions and auxiliary transmissions, leave the transmission in neutral and allow the transmission lubricating oil to warm up (approximately 3-5 minutes) before operating vehicle. CAUTION Anti-Theft (Optional) Always unplug heater before starting the en- gine.
Damage to the cooling system could occur if the heater is not turned OFF (un- plugged). Certain vehicles have functionality to require an operator to enter a 4 digit code to start the vehicle. Depending on engine make, when the temperature falls below -10°F (-24°C), the block heater is required. If the wrong code is entered, the display will show a lock icon. The unlock icon will appear once the correct code is entered and the operator will have up to 6 minutes to turn the ignition on. If the engine is not Engine Block Heater (Optional) To preheat the engine before starting, plug the optional engine block heater into a Y53-6096-1A1 (01/17) 97