Detroit Diesel Electronic Controls (DDEC) System NOTE: The Stop Engine Override Switch and the Diagnostic Request Switch are the same. NOTE: Holding down the Stop Engine Override Switch will not prevent the engine shutdown sequence. You must continue to reset the automatic shutdown system by pressing the Stop Engine Override Switch at intervals of approximately 15 to 20 seconds. It takes 30 seconds from the time the automatic shutdown sequence begins until engine shutdown. Therefore, the operator must press the override switch just prior to engine shutdown and continue to do so until the vehicle can be brought to a stop in a safe location.
Immediate Speed Reduction The immediate speed reduction option will bring engine rpm back to a predetermined speed, but will not shut down the engine. The engine should not be restarted after it has been shut down by the engine protection system, unless the problem has been located and corrected. Red Stop Lamp The conditions that will cause the RSL (Stop Engine) to come on are: High coolant temperature Loss of coolant High oil temperature Low oil pressure Auxiliary shutdown If the malfunction is intermittent, the lights will come on and go off as the computer senses the changing engine condition.
Diagnostic Tool The diagnostic tool for Detroit Diesel Electronic Control is the Detroit Diesel Diagnostic Link (DDDL 7.X). DDDL 7.X requirements are listed earlier in the manual under Data Recording Capability. The temperature of air in the intake system is increased with the addition of EGR. DDEC is programmed to reduce fueling (power) for a short time to reduce air and coolant temperatures when necessary. DDEC will store an information code that this event occurred, but no corrective action is required as this action is designed to maintain operation without a noticeable affect on vehicle performance. 42 All information subject to change without notice.
Copyright © 2014 DETROIT DIESEL CORPORATION DDC-SVC-MAN-0175