MAN — Diagnostic Tool

DD Platform EuroIV Operators Manual Flashing Malfunction Codes All malfunction codes are four digits. The malfunction code recorded in the computer memory will remain until it is erased by a technician. The flashing malfunction code can also be obtained by the operator. To support flashing codes, a Stop Engine Override/Diagnostic Request Switch must be configured and the AWL (Check Engine) and RSL (Stop Engine) must be hard- wired. The CPC cannot flash these lamps if they are not hard-wired. The flashing code feature may be activated by satisfying one of the following conditions: Engine speed is position. Idle Governor is active and the Stop Engine Override Switch is put in the ON position.

Vehicle speed is Override Switch is put in the ON position. The flashing code feature is deactivated once the Stop Engine Override Switch is returned to the OFF position or the listed conditions are no longer satisfied. Only one light will be flashing codes at any time. All codes will be flashed twice. The inter-digit pause is 1.5 seconds. The pause between codes is 3.5 seconds. The same 3.5-second pause occurs as the switch is made from RSL (Stop Engine) to AWL (Check Engine). When code flashing is initiated, the active codes will be flashed on the RSL (Stop Engine). Then the inactive codes will be flashed on the AWL (Check Engine).

When all the inactive codes have been flashed, the process of flashing all the active codes followed by all the inactive codes will repeat until the conditions for code flashing are no longer satisfied. If there are no active or inactive faults, the number 3 is flashed once followed by a gap of 3 seconds. All information subject to change without notice. 43 DDC-SVC-MAN-0175 Copyright © 2014 DETROIT DIESEL CORPORATION