MAN — Monitoring the Serpentine Belts

DD Platform EuroIV Operators Manual Adjusting the Valve Lash NOTE: Proper valve lash clearance allows the engine to produce the best possible performance with the lowest emissions. Valve lash adjustments should be performed by an authorized Detroit™ maintenance or repair facility. Perform a valve lash adjustment as scheduled for the appropriate engine duty cycle. Monitoring the Belt Tensioner The engine is equipped with two engine belt tensioners to ensure the belts are neither too tight nor too loose. Belts that are too tight impose extra loads on the crankshaft, fan, and alternator bearings shortening both belt and bearing life.

A loose belt will slip and generate excessive heat that may cause damage to the belt and accessory drive components. WARNING: PERSONAL INJURY To avoid injury from rotating belts and fans, do not remove and discard safety guards. 1. Inspect the belt tensioner for wear or damage. 2. If damage is found it may need to be replaced by an authorized Detroit™ maintenance or repair facility. Monitoring the Serpentine Belts Two poly-V-belts (8 and 9) are used on the engine for On-Highway Vehicle applications. One belt drives the fan hub and the other belt drives the remaining accessories.

To provide proper running tension, the current engine uses an automatic fan hub belt tensioner (6) and an accessory belt tensioner (2). Automatic belt tensioners require no adjustment. All information subject to change without notice. 69 DDC-SVC-MAN-0175 Copyright © 2014 DETROIT DIESEL CORPORATION