Routine Preventive Maintenance Replacement of Belts Replace the drive belts every 2,000 hours or 300,000 miles (480,000 km). Inspection of the Air Intake System Perform the following maintenance on the Air Intake System: 1. Inspect all the connections in the air system to make sure they are tight and leak-free. 2. Check all hoses and ducting for punctures, deterioration, or other damage and replace, if necessary. Monitoring the Air Cleaner The engine is equipped with an engine-mounted air cleaner that is flat in design to accommodate various vehicle packages. Replace dry type air cleaner elements when the maximum allowable air intake restriction has been reached. 1.
Inspect the air cleaner element every 50,000 miles (80,000 km) or more often if the engine is operating under severe dust conditions. Replace the element, if necessary. 2. Check the gaskets for deterioration and replace, if necessary. 3. If the dry type air cleaner is equipped with an aspirator, check for aspirator damage or clogging. Clean, repair or replace, as necessary. NOTICE: Do not allow the air inlet restriction to exceed 20 in. H2O (5.0 kPa) under any engine operating conditions. A clogged air cleaner element will cause excessive intake restriction and reduced air supply to the engine resulting in increased fuel consumption, inefficient engine operation, and reduced engine life. 4.
Inspect the entire air system for leaks daily. 70 All information subject to change without notice. Copyright © 2014 DETROIT DIESEL CORPORATION DDC-SVC-MAN-0175