MAN — Installation of the Fuel Prefilter

How to Procedures WARNING: PERSONAL INJURY To prevent the escape of high pressure fuel that can penetrate skin, ensure the engine has been shut down for a minimum of 10 minutes before servicing any component within the high pressure circuit. Residual high fuel pressure may be present within the circuit. NOTICE: At cold temperatures (-40° C or -40° F), DO NOT remove the filter elements from the caps unless the intent is to replace the filter elements. Repeated removals at cold temperatures may break the filter element tabs. Removal of the Fuel Prefilter Remove the prefilter as follows: 1. Using a 36 mm socket, unscrew the prefilter cap. 2.

Pull the cap and prefilter straight up and out of the fuel filter housing. 3. Remove the prefilter (1) from the prefilter cap (2) by placing the filter on a solid surface and apply pressure on prefilter cap (2) at an angle. 4. Discard the prefilter cap seal ring. Installation of the Fuel Prefilter Install the fuel prefilter as follows: 84 All information subject to change without notice. Copyright © 2014 DETROIT DIESEL CORPORATION DDC-SVC-MAN-0175