MAN — Installation of the Fuel Prefilter

DD Platform EuroIV Operators Manual NOTE: If a filter service is being performed, replace all other filters before priming. 1. Install a new prefilter cap seal ring on to the prefilter cap. 2. Snap new prefilter into the prefilter cap. 3. Apply a thin coat of petroleum-based lithium grease to the prefilter cap seal ring and the prefilter seals (1). 4. Install the prefilter into the fuel filter module. 5. Turn the cap counterclockwise until a click sound is made, then turn clockwise and hand tighten. 6. Torque prefilter cap to 55-60 N·m (41-44 ft·lb). 7. Once all required filters have been changed, prime the fuel system using the ESOC 350, J-47912 or the engine mounted hand primer. WARNING:

ENGINE EXHAUST To avoid injury from inhaling engine exhaust, always operate the engine in a well-ventilated area. Engine exhaust is toxic. WARNING: PERSONAL INJURY To avoid injury before starting and running the engine, ensure the vehicle is parked on a level surface, parking brake is set, and the wheels are blocked. All information subject to change without notice. 85 DDC-SVC-MAN-0175 Copyright © 2014 DETROIT DIESEL CORPORATION