DD Platform EuroIV Operators Manual Improper testing Detroit Cooling System Maintenance Products Detroit Genuine Coolant Supplemental Coolant Additives are water-soluble chemical compounds. These products are available in coolant filter elements, liquid packages, and in fully formulated Detroit Genuine Coolant antifreeze and are available to do maintenance on the cooling system. Summary of Coolant Recommendations The Detroit™ coolant recommendations for the engine are: WARNING: HOT COOLANT To avoid scalding from the expulsion of hot coolant, never remove the cooling system pressure cap while the engine is at operating temperature.
Wear adequate protective clothing (face shield, rubber gloves, apron, and boots). Remove the cap slowly to relieve pressure. Always maintain the engine coolant to meet Detroit™ specifications. Only use water that meets the specifications listed in this manual. Distilled, demineralized (reverse osmosis) or de-ionized water is preferred. The proper dosage of inhibitors be included in the coolant at initial fill for all Detroit™ engines. This dosage is usually included in the fully formulated antifreeze used, or it may need to be added if water alone or if less than 50% antifreeze is used. The user is urged to use the full text of this section to determine the proper dosage.
Mixing of different manufacturers technologies (brands) could cause cooling system problems. Maintain the inhibitor at the prescribed concentration. Test the nitrite concentration by using a titration kit or Detroit Genuine Fluid Analysis 3-Way Coolant Test Strips. Add Supplemental Coolant Additives only if the nitrite concentration is below 900 PPM. NOTE: If the nitrite concentration exceeds 3,200 PPM, the coolant must be drained and replaced with new coolant. A thorough cleaning of the cooling system may be required. Do not use another manufacturer's test kit to measure the Supplemental Coolant Additive concentration of Detroit™ maintenance products.
Premix coolant makeup solutions to the proper concentration before adding to the cooling system. Do not mix Organic Acid Technology and other coolants in the same engine. Do not use automotive coolants. Where antifreeze/boil over protection is required, use only antifreeze that meets TMC RP-329 Type A specification or ASTM Standard D 6210 Type A for Ethylene Glycol. Always maintain coolant at the proper level. Do not use the following in Detroit™ engine cooling systems: All information subject to change without notice. 99 DDC-SVC-MAN-0175 Copyright © 2014 DETROIT DIESEL CORPORATION