How to Procedures For best results, take the test while the coolant is between 10.0–60° C (50–140° F). Wait at least 60, but not longer than 75 seconds, before reading the nitrite level. NOTE: A factory coolant analysis program is available through authorized Detroit™ service outlets. Use the test strips as follows: NOTE: Color change of the additive indicator (middle pad) indicates the presence of inhibitor that is not approved by Detroit™. 1. Dip the strip into coolant for one second. Remove and shake briskly to eliminate excess fluid. 2. Immediately compare the pad end (% glycol) to the color chart on the container. 3.
Sixty seconds (one minute) after dipping, compare the nitrite pad to the color chart. 4. Promptly replace and tighten the test strip container cap after each use. Discard unused strips if they have turned light pink or tan. Removal of Dropout Excessive amounts of some inhibitors in the coolant can cause a gel or crystalline deposit that reduces heat transfer and coolant flow. The deposit, called "dropout," takes the color of the coolant when wet, but appears as a white or gray powder when dry. It can pick up solid particles in the coolant and become gritty, causing excessive wear of water pump seals and other cooling system components. WARNING:
PERSONAL INJURY To avoid injury when using caustic cleaning agents, follow the chemical manufacturers usage, disposal, and safety instructions. NOTE: If the gel is allowed to dry, it is necessary to disassemble the engine and clean it with a caustic solution or physically clean individual components. Remove the wet gel using a non-acid (alkali) type heavy-duty cleaner, such as Detroit Genuine Cooling System On-Line Cleaner (sodium nitrite/sodium tetra borate). Chronic Coolant System Problems The most commonly seen coolant system problems result from maintenance and formulation factors such as:
Hard water Dilution of the coolant by the addition of untreated water Over dosage or under dosage of corrosion inhibitors Improper corrosion inhibitor (most often phosphate) Mixing Supplemental Coolant Additives 98 All information subject to change without notice. Copyright © 2014 DETROIT DIESEL CORPORATION DDC-SVC-MAN-0175