DD Platform EuroIV Operators Manual Coolants Not Recommended The following coolants are not recommended for use in Detroit™ engines. Antifreezes and Coolants Containing Phosphate – Coolants containing phosphate are not recommended. Drop out, overheating, and water pump seal failures can result from the use of coolant or inhibitor packages based on phosphate. Automotive Type Coolants – These coolants generally contain high levels of phosphate and silicate, offer no liner pitting protection, and are not suitable for use in Detroit™ engines.
Methyl Alcohol-Based Antifreeze – Methyl Alcohol-Based Antifreeze must not be used because of its effect on the non-metallic components of the cooling system and its low boiling point. Glycol-Based Coolants Formulated for HVAC – These coolants formulated for Heating/Ventilation/Air Conditioning (HVAC) should not be used. These coolants generally contain high levels of phosphates, which can deposit on hot internal engine surfaces and reduce heat transfer. Additives Not Recommended The following additives are not recommended for use in Detroit™ engines. Soluble Oil Additives – These additives are not approved for use in Detroit™ engine cooling systems.
A small amount of oil adversely affects heat transfer. For example, a 1.25% concentration of soluble oil increases fire deck temperature 6%. A 2.50% concentration increases fire deck temperature 15%. The use of soluble oil additives may result in engine overheating and/or failure. Chromate Additives – These additives are not approved for use in Detroit™ engine cooling systems. Chromate additives can form chromium hydroxide, commonly called "green slime." This, in turn, can result in engine damage due to poor heat transfer.
Cooling systems operated with chromium-inhibited coolant must be chemically cleaned with a recommended cooling system cleaner/ conditioner (or equivalent sulphuric acid/sodium carbonate cleaner) and flushed. Testing for Supplemental Coolant Additives Detroit Genuine Fluid Analysis 3–Way Coolant Test Strips should be used to measure nitrite and glycol concentrations. Cavitation/corrosion is indicated on the strip by the level of nitrite concentration. Freeze/boil over protection is determined by glycol concentration. WARNING: HOT COOLANT To avoid scalding from the expulsion of hot coolant, never remove the cooling system pressure cap while the engine is at operating temperature.
Wear adequate protective clothing (face shield, rubber gloves, apron, and boots). Remove the cap slowly to relieve pressure. All information subject to change without notice. 97 DDC-SVC-MAN-0175 Copyright © 2014 DETROIT DIESEL CORPORATION