How to Procedures 9. Check for leaks. 10. Allow the engine to reach operating temperature of 60° C (140° F). NOTICE: Increasing engine speed above idle before oil pressure has stabilized may cause severe engine damage. 11. Increase engine speed to 1800 rpm for three minutes. 12. Return the engine to idle and allow to idle for approximately one minute, then shut down the engine. 13. Check for leaks. 14. If engine still fails to start, contact an authorized Detroit™ repair facility. How to Clean an Engine Observance of all environmental protection regulations is required. Use high- pressure equipment as follows: CAUTION:
EYE INJURY To avoid injury from flying debris, wear a face shield or goggles. NOTICE: To prevent damage to engine components, keep the water moving at all times while cleaning. Never direct water onto electrical components, plug connectors, seals or flexible hoses. Information on suitable cleaning and protective products is available from any authorized dealer. Note the equipment manufacturer's operating instructions. Use the following minimum working distance between the high-pressure nozzle and the surface being cleaned: Approximately 28 in. (700 mm) for circular pattern jets Approximately 12 in. (300 mm) for 25-degree flat jets and dirt cutters Power clean the engine as follows: 1.
Allow engine to cool down to room temperature before spraying the engine. NOTICE: Avoid all of the electrical connections with direct water or steam spray or damage can result. 2. Thoroughly clean the entire engine using a steam cleaner or high pressure washer with mild soap and warm water. WARNING: EYE INJURY To avoid injury from flying debris when using compressed air, wear adequate eye protection (face shield or safety goggles) and do not exceed 276 kPa (40 psi) air pressure. 104 All information subject to change without notice. Copyright © 2019 DETROIT DIESEL CORPORATION DDC-SVC-MAN-0209